DrawBlade.ps 1 Add arc radius lines for illustrations(0=no? 1?) 3 # of rocker length segments(2? 3?) 96.0000000 Rocker radius (inches) 8.00000000 Curved length of rocker segment (inches) 0.00000000 x value of leftmost point on blade(0?) 0.00000000 y value of lowest point on blade (0?) 27.0000000 Rocker radius (inches) 1.50000000 Curved length of rocker segment (inches) 12.0000000 Rocker radius (inches) 1.00000000 Curved length of rocker segment (inches) 4 # of toepick teeth 140.000000 Angle from curve to drag pick(140?) 0.250000000 Length of back of that tooth 70.0000000 Degrees in angle at bottom of tooth 0.250000000 Length of front of that tooth 70.0000000 Degrees from last tooth to this tooth 0.250000000 Length of back of that tooth 70.0000000 Degrees in angle at bottom of tooth 0.250000000 Length of front of that tooth 70.0000000 Degrees from last tooth to this tooth 0.250000000 Length of back of that tooth 70.0000000 Degrees in angle at bottom of tooth 0.250000000 Length of front of that tooth 70.0000000 Degrees from last tooth to this tooth 0.250000000 Length of back of that tooth 70.0000000 Degrees in angle at bottom of tooth 0.250000000 Length of front of that tooth 1.00000000 Height of runner(0 to not draw top? 1?) 0.200000003 Scaled Tic Length (inches) (0=none; .2?) 0.500000000 Paper margin size (inches) (.5?) 8.50000000 X-axis paper size(8.5?) 14.0000000 Y-axis paper size(11?) 90 Rotation angle(0? 90? -1 to try diagonal fit) 1.00000000 Scale factor(1? .5?) 0.299999993E-01 Line width (inches) (.01?) 2 1=Left Align,2=Right Align)